ACETAL SHEET, ACETAL DELRIN SHEET

We now custom cut at a small additional charge, $1.00 per piece. Here's how to get it done:

1). Choose the stock size that is larger than the size you need and enter the quantity. Click "add to cart"

2). In the text box BELOW the item on the checkout page, write the size that you would like it cut to. Specify the size in whole and fractional INCHES. Example: 23 X 16-1/4. No need to put inch marks ("). We will consider all figures to be inches-DO NOT SPECIFY IN FEET. Do not put any other information in the text box, only the size.

3). Checkout, or continue shopping. Thats it! We will custom cut it to your specified size, we keep any cutoff pieces.

B.) Except as noted above, cutting tolerance is +/- 1/16". This means that your piece may be over or under your requested size by 1/16". Note that the initial tolerance of the piece we begin with is +/- 1/4", which may affect your requested size. As an example, say you wanted our 1/4 X 24 X 24 custom cut to 24 X 19. Since the piece we start with is already 1/4" undersize due to the initial tolerance, we are cutting from a piece that is actually 23-3/4 X 23-3/4. Therefore, the piece we send you will be actually 23-3/4 X 19. If it had to be exactly 24, you would have to order a larger size. We cannot accept returns because you failed to recognize this, so please be sure!

C). Edges are sawcut. We do not finish edges. Because of tolerance and thickness variations, do not expect all pieces to fit together properly if you are building a box, aquarium, etc. Finish sizing is up to you.

D). If you are ordering MANY of the same item and only want SOME of them custom cut, enter them separately. For example, if you want 5 pieces 24 X 24 but only need 2 of them custom cut, place '2' in the quantity box, add it to your cart, then specify the custom size. Then go back to that page and put '3' in the quantity box and add it to your cart.

E). Cutting charges will be added.