Acrylic Sheet, 1/4" Thick
Tolerances: Thickness +/- 15%. Length and width +/- 1/4". When we buy 48" X 96" sheets from the manufacturer, they give us a tolerance of +/- 1/4" on length and width. We also use a 3/16" thick blade to cut heavy materials, which reduces the finished size of your sheet. Sheets under 48" X 96" will likely be under, not over. We will be happy to quote a price for sheets that you require to be at or over the specified size.
We now custom cut at a small additional charge, $1.00 per piece. Here's how to get it done:
A). We will not cut a piece into many smaller pieces, we will only reduce it to one size. We keep any cutoffs. We cannot do shapes other than a square or rectangle.
B.) Except as noted above, cutting tolerance is +/- 1/16". This means that your piece may be over or under your requested size by 1/16". Note that the initial tolerance of the piece we begin with is +/- 1/4", which may affect your requested size. As an example, say you wanted our 1/4 X 24 X 24 custom cut to 24 X 19. Since the piece we start with is already 1/4" undersize due to the initial tolerance, we are cutting from a piece that is actually 23-3/4 X 23-3/4. Therefore, the piece we send you will be actually 23-3/4 X 19. If it had to be exactly 24, you would have to order a larger size. We cannot accept returns because you failed to recognize this, so please be sure!
C). Edges are sawcut. We do not finish edges. Because of tolerance and thickness variations, do not expect all pieces to fit together properly if you are building a box, aquarium, etc. Finish sizing is up to you.
D). If you are ordering MANY of the same item and only want SOME of them custom cut, enter them separately. For example, if you want 5 pieces 24 X 24 but only need 2 of them custom cut, place '2' in the quantity box, add it to your cart, then specify the custom size. Then go back to that page and put '3' in the quantity box and add it to your cart.
E). Cutting charges will be added.
Your Shopping Cart At freckleface.com